Mission Planning and Data Capture
Plan a mission in AMC
Flux sensor presets are available in AMC under the camera presets. Update to AMC version 1.36.22 or later
In AMC, go to the plan screen and tap Pattern --> Survey or Corridor Scan and draw out the area you would like to scan.
Next, select your Flux variant under the camera settings. This will apply the default settings for Flux and simplify the mission planning process.
We recommend the following mission settings for Flux:
Flight Height
Between 20 m to 150 m, depending on surrounding obstacles.
Between 20 m to 150 m, depending on surrounding obstacles.
Between 20 m to 150 m, depending on surrounding obstacles.
Track Separation
Set automatically if Flux H1 is selected
Set automatically if Flux L1 is selected
Set automatically if Flux O1 is selected
Speed
2 to 15 m/s, depending on the point density required. The slower, the higher the point density.
2 to 10 m/s, depending on the point density required. The slower, the higher the point density.
2 to 15 m/s, depending on the point density required. The slower, the higher the point density.
If you are using terrain following, use max climb and descent rates <1.5 m/s
Connecting an iPad to Pilot Pro
In the app store, download the Freefly Flow app. Then, follow these instructions to connect your iPad to Pilot Pro using the included ethernet to USB-C cable.
Use the following settings on the iPad:
IP address: 192.168.144.120
Subnet mask: 255.255.255.0
Start LiDAR capture and execute the mission
When you are ready to execute your planned mission, power on the drone. The LiDAR sensor will start loading, and the LED will blink blue. Once it is ready for data capture, the LED will turn solid green.
If an iPad is connected to Pilot Pro, you can connect the Flow app to Flux and see Flux status including:
GNSS satellites and accuracy
Lidar scanning mode and points/second
USB storage remaining
Internal temperature
Flux relies heavily on GNSS for good performance
For the best results, wait for the left and right GNSS modules to both have 22+ satellites for >1 minute before starting to record and takeoff
Before takeoff, push the REC button on the Flux LiDAR or in the Flow app to start capturing LiDAR data. Once the LED turns red, begin flying the mission. There is no need for calibration figures or particular paths.
The L1 will likely display 0 pts (red) while Astro is on the ground. This is normal, the L1 minimum range is 1 meter and L1 will be able to collect points while flying.
Flux will calibrate itself on the way to the entry point of the mission.
We recommend placing the start point as the farthest point from the takeoff point. This will give Flux the best calibration and will allow Astro to be closer to the home point at the end of the mission, allowing for longer flight times before the time-based RTL triggers
Blinking Blue
Sensor loading
Blinking Yellow
GNSS starting and acquiring satellites
Blinking Magenta
Flash drive missing, not ExFAT formatted or busy after recording.
Solid Green
Sensor ready to start LiDAR capture. Standby.
Solid Red
Sensor recording.
After landing, push the REC button to stop recording, either in the app or on the lidar. The LED will start blinking magenta, indicating the Flash Drive is busy. Once it is ready, the LED will go back to solid green.
Remember to stop recording before turning off the aircraft! If Flux is powered down while recording, the scan data will be corrupted and may not be recoverable.
Process your LiDAR data in the field just after landing
Remove the Flash Drive from the LiDAR sensor and connect it to the iPad to process the data
Processing LiDAR data on an iPadLast updated