FS500 aircraft → Install SL8, Tether Air Unit.
XT90 cable → connect to tether Air Unit
Place aircraft in a takeoff area with at least a 5m/16 feet radius of clear space.
Unfold aircraft and latch booms, remove proptectors.
Connect AC power to tether unit, don’t turn on yet.
It is suggested that the pilot wears sunglasses or has them at the ready.
Pilot pro → booted and connected
Tether strain relief clip → attached to Astro
Tether cable → constrained out of props
LP-12 plugged into to tether air unit.
Tether cable → extra 3m/~10ft spooled out
Astro powered on via single SL8 battery
Pilot pro → D2 dial set to 0%
Tether ground unit → check AC power is supplied
Tether ground unit → activate blue breaker switch
Tether ground unit → flip battery backup switch on
Pilot pro → Flying Sun app → Enable high voltage
Flying Sun app → confirm high voltage on
*** DO NOT TOUCH THE TETHER AIRUNIT OR CABLE WHILE HIGH VOLTAGE IS ACTIVE.
750 VOLTS CAN KILL YOU***
Pilot pro → D2 dial → turn on, confirm lights are working
Pilot pro → D2 dial → turn off
Pilot pro → AMC → Ensure Astro is in Position mode, ready to arm
Take off
Pilot pro → Dim the lights using D2 knob
Land
Pilot pro → Flying Sun app → Disable high voltage
Flying Sun app → Confirm high voltage off
Astro → turn off SL8 → disconnect tether cable
Pilot pro → tether app → hold takeup button → Cable will retract
Tether Ground Unit → AC power button → Hold down to turn off
Tether Ground Unit → Backup power switch off
Pack up
Last updated 16 days ago